

Spray Foam System in Kennan for flat roofs with insulation and waterproofing needs
Commercial Roofing That Insulates While It Protects
Goldstar Roofing & Coatings applies closed-cell spray polyurethane foam systems primarily to commercial flat roofs and agricultural barns in Kennan, where older structures often lack sufficient insulation and leak resistance. The system begins with thorough pressure washing to remove debris and contaminants from the existing roof deck, followed by foam application and a two-part protective coating. This approach addresses both thermal performance and water intrusion without the weight or disruption of full roof replacement.
The closed-cell spray foam bonds directly to the prepared roof deck and provides continuous insulation across seams and penetrations that typically create thermal bridges in traditional roofing. A Benchmark base coat is applied over the foam, followed by a Puma top coat specifically formulated to resist ultraviolet degradation, which would otherwise break down the foam layer and compromise its insulating properties. The coating system extends the life of the foam while maintaining a watertight seal.
Schedule a roof assessment to determine if your flat roof structure is suitable for foam application and protective coatings.
How the System Addresses Flat Roof Challenges
Flat roofs accumulate standing water and lack natural drainage, which accelerates coating wear and seam failure over time. The spray foam creates a slightly crowned surface that improves water flow toward drains while adding insulation value that reduces heating costs in Wisconsin winters. The multi-layer coating system protects the foam from UV exposure, which can degrade uncoated foam in as little as one to two seasons of direct sunlight.
After the Puma top coat application, the roof surface resists ponding water and reflects solar heat, which reduces thermal cycling stress on the building envelope. Goldstar Roofing & Coatings includes a twenty-year warranty covering material failure and workmanship, which begins after the final coating cures. The roof becomes a seamless, monolithic surface without the fastener penetrations or overlapping seams that create common leak points in mechanically attached systems.
The system works best on structurally sound decks with minimal deflection, as foam follows the existing surface profile and does not correct severe sagging or structural damage. Buildings with significant roof movement or unresolved deck issues may require structural reinforcement before foam application to prevent cracking or delamination under stress.
What Building Owners Ask About Foam Systems
Commercial building owners in Kennan often weigh foam systems against full roof replacement or single-ply membranes, particularly when evaluating long-term insulation improvements and project costs.
What preparation does the roof deck require before foam application?
The roof surface is pressure washed to remove dirt, oils, and loose material that would prevent proper foam adhesion, and any wet insulation or damaged decking is removed and replaced before foam is sprayed.
How does closed-cell foam differ from open-cell foam in roofing?
Closed-cell foam provides both insulation and a water barrier because its cell structure does not allow moisture penetration, while open-cell foam absorbs water and is unsuitable for exterior roofing applications.
Why does the foam need two separate coating layers?
The Benchmark base coat seals the foam surface and provides initial UV protection, while the Puma top coat adds long-term weather resistance and reflectivity that prevents heat absorption and foam degradation.
When does a barn or commercial building benefit most from spray foam instead of membrane systems?
Buildings with poor insulation, high heating costs, or irregular roof surfaces that make membrane installation difficult see the greatest return from spray foam, which conforms to any shape and adds significant R-value in a single application.
What does the twenty-year warranty cover on spray foam systems?
The warranty includes material defects, coating failure, and workmanship issues that result in leaks or foam degradation, provided the roof is maintained and not subject to physical damage or structural failure outside the system's control.
Goldstar Roofing & Coatings evaluates roof structure, existing insulation levels, and drainage conditions before recommending a spray foam system. Request a site inspection to review your building's roof deck condition and insulation needs.